-
White Morse Code H Heliport Beacon Light 2500cd 110-240VAC Helipad Light
AH-HP-B2 LED Heliport Beacon The heliport beacon shall be located on or adjacent to the heliport preferably at an elevated position and so that it does not dazzle a pilot at short range. AH-HP-B2 flashes white color 4 times/0.8second and stop for 1.2s, then start new circle for 2seconds(0.8s+1.2s ). Compliance ICAO Annex 14 Volume ǁ Heliports 5.3.2 CAP 437 Electrical Power supply available in DC(12, 48VDC) or AC(110-240VAC) Physical Clear polycarbonate lens for converging
-
AH-HP-F1 Led Heliport Flood Light White 24 Hours Operation 110-240vac
AH-HP-F1 LED Heliport Surface Flood Light LED Surface Heliport Flood Light is used for illuminate the whole heliport area at night. It is specially designed for helipads/Helideck, providing glare-free, uniform surface lighting for landing and loading activities. LED Surface Floodlights improve pilot depth perception by reflecting the surface of the helipad/helideck, allowing pilots to better estimate their altitude during landing. Compliance ICAO Annex 14 Volume ǁ Heliports 5
-
TLOF LED Heliport Helideck Elevated Light FATO Taxiway Light
AH-HP-E Serial LED Heliport-Helideck Elevated Light AH-HP-E Serial Heliport Elevated lights should not exceed a height of 25cm for Surface-level and Elevated heliports, not exceed a height of 15 cm for helideck. There is a fragile coupling in the base connection for heliport so if aircraft hit the light by accident, the base will break immediately to avoid more damage. The lights could be used as FATO light, TLOF lights, Taxiway lights. Compliance ICAO Annex 14 Volume ǁ
-
CHAPI Heliport Approach Path Indicators Lights Red/Green/White AC220V Steady Burning
AH-HP-CHAPI LED CHAPI Heliport Approach Path Indicators helipad light heliport lighting The LED CHAPI Heliport Approach Path Indicators (CHAPI) uses LED technology to provide the pilot with safe and accurate glide slope on final approach to the helipad. A set of two LED CHAPI Light Housing Assemblies (LHAs) are seen by the pilot in combinations of white, green and red to indicate a path that is too high, too low or within the 6° ±0°15' glide slope. Solar power system is
-
AH-HP-H Helideck Circle-H Light Green / Yellow Steady Burning 48VDC
AH-HP-H Helideck Circle-H Light Helideck Circle-H Light is for the heliport identification marking “H” and the circle, The design of thickness (＜25MM ) make it easily installed and suitable for all kinds of heliport. Compliance ICAO Annex 14 Volume I, Appendix I Nov. 2016, figure A1-1-Colors for aeronautical Ground lights CAP 437 Features Electrical LED as light source saving power consumption and maintenance, 95% less power than equivalent incandescent light Power supply
-
Red Green White CHAPI Helipad LED Lights Approach Path Indicators
Red Green White CHAPI Helipad LED Lights Approach Path Indicators AH-HP-CHAPI LED CHAPI Heliport Approach Path Indicators The LED CHAPI Heliport Approach Path Indicators (CHAPI) uses LED technology to provide the pilot with safe and accurate glide slope on final approach to the helipad. A set of two LED CHAPI Light Housing Assemblies (LHAs) are seen by the pilot in combinations of white, green and red to indicate a path that is too high, too low or within the 6° ±0°15' glide
-
ICAO Standard LED Helipad Landing Lights Green White Yellow Blue Red
ICAO Standard LED Helipad Landing Lights Green White Yellow Blue Red AH-HP-I Serial LED Heliport Inset Light Heliport Inset light is always be installed at locations where the lights are frequently knocked down by aircraft or maintenance vehicles. It could be used as Aiming point light, perimeter light of FATO (Final approach and take-off areas), TLOF (Touchdown and lift-off areas), taxiway, Flight path alignment guidance lighting, etc. The emitting color is green or yellow
-
AH-HP-I-FATOL LED Helipad Landing Lights Heliport Final Approach And Take Off Area Lighting
AH-HP-I-FATO(L) LED Heliport Final Approach and Take-off Area Lighting The objective of a FATO lighting system for onshore surface-level heliports is to provide to the pilot operating at night an indication of the shape, location and extent of the FATO. FATO lights shall be placed along the edges of the FATO and be fixed omnidirectional lights showing white. 8inch International standard mounting for aerodrome inset light. Compliance ICAO Annex 14 Volume ǁ Heliports 5.3.7 FAA
5s
+1
Submission successful!
